--------------------------------------------------------------------------------------------
***		EasyEcu 3+ firmware 3.8.3.13 (07.07.2019)		***

CAUTION! Firmware is compatible with EcuProg 3.8.3, Build date: Jan 07 2019 21:51:56
         In this version maps and configuration saving in memory of ECU has been changed.
         Make a copy of configuration and maps before update will be performed.
         After update restore configuration and maps from saved project.

New features:
- fifth ignition event has been added (Ignition event 5). It allows run V10 or R5 engines.
  R5 settings as V10 but run 5 individual coils in wasted spark mode
- Flat shift has bee added, activation on input I/O #1 (pin 1E right connector)
- measurement of addition temperature (e.g. oil temp) on NTC input (pin 1H right connector) hes been added
- infinitely adjustable (custom value) tacho signal divider has been added
- multiplier for PWM Boost map dependent of interpolation signal between sets of maps #1 i #2 has been added

New parameters:
- Ignition -> Ignition outputs -> Ignition event 5
- Sport -> Flat shift -> Active flat shift
- Sport -> Flat shift -> Flat shift RPM
- Sensor calibration -> NTC sensor
- Boost settings -> PWM multiplier for map #2
- Outputs -> Tacho custom divider
	
Fixed issues:
--------------------------------------------------------------------------------------------